Fuse Protection
The safety fuse pauses a running campaign when too many dials fail in a short time. It stops a bad list or a blocked number from burning through your balance and hurting your caller IDs.
Go to Outreach › Campaigns › Campaigns, open a campaign, then Settings › Grouping and safety › Edit.
Turn on the fuse

- Set Safety Fuse Threshold to a percentage.
- Set Fuse Window.
- Click Save.
The fuse is OFF by default on new campaigns.
| Setting | Options | Default | What it does |
|---|---|---|---|
| Safety Fuse Threshold | OFF, 80%, 70%, 60%, 50%, 40%, 30%, 20% | OFF | Failure rate that trips the fuse. Lower is stricter. |
| Fuse Window | 1 Hour, 30 Minutes, 15 Minutes, 10 Minutes | 30 Minutes | Rolling time window used to measure the failure rate. |
How it trips
While the campaign is running, Taalk looks at the calls made in the last Fuse Window:
Failure rate = failed calls ÷ (completed calls + failed calls)
If the failure rate is above the threshold, the fuse trips. Calls still in progress don't count.
[Confirm] Which call outcomes count as failed (for example invalid or disconnected numbers and carrier rejections) versus completed (answered, voicemail, no answer), and how often the fuse is checked during a run (C12).
[Confirm] With Safety Fuse Threshold set to OFF, the fuse never trips (C12).
What happens when it trips
- The run is paused. The campaign header shows Paused and the button changes to Resume.
- Every Fuse Melt notification on the campaign is sent.
Nothing else changes. Contacts, results and settings stay as they were.
Get told when it trips
Add a Fuse Melt notification on the campaign's Notifications tab. See Campaign Notifications and Alerts.
| Type | What you get |
|---|---|
| "Campaign name has been paused for high failure rate", with the failure rate | |
| Webhook | A request to your URL with the campaign ID and failureRate (a fraction, for example 0.45 for 45%) |
| Slack Channel | Not sent for Fuse Melt. Use Email or Webhook. |
Resume after a trip
- Find the cause. Check the Reporting tab and the call log for failed calls. Common causes are a bad or old list, wrong number format, or a flagged caller ID.
- Fix it: clean the list, change the caller ID, or remove bad contacts.
- Click Resume in the campaign header.
The window is rolling, so the failures from before the pause still count for up to one Fuse Window. If you resume right away without fixing anything, the fuse can trip again quickly.
Pick a threshold
| Your list | Suggested start |
|---|---|
| New source you haven't tested | A strict threshold, such as 20% or 30% |
| Trusted, cleaned data | A looser threshold, such as 50% |
| Old lists being re-run | Somewhere in between, then adjust |
Watch the first runs and adjust. These are starting points, not benchmarks.
Fuse vs. stop condition
| Fuse | Stop Condition | |
|---|---|---|
| Acts on | The whole campaign | One contact |
| Triggered by | A high failure rate | A result for that contact (answer, transfer, success, click) |
| Result | The run pauses | That contact isn't dialed again |
See Retries, Double-Dial and Stop Conditions.
What the fuse can't do (yet)
- No minimum number of calls before it can trip. On a small test list, a few failures can trip it.
- No automatic resume. You always resume by hand.